Details

---

Specifications

SKU: Sika MonoTop-222

Weight(grams): 25000

Dimension: 40 cm (Length) x 30 cm (Width) x 50 cm (Height)

Product details of SIKA Sika MonoTop-222 Patch Repair #25KG (GREY)

• ▪ Non-bleeding and non-segregation
• ▪ Shrinkage-compensating
• ▪ High early compressive and flexural strength
• ▪ Non-corrosive and non-toxic
• ▪ Chlorides and iron free
• ▪ Pre-mixed to eliminate site variations and errors

DESCRIPTION
Sika MonoTop®-222 Patch Repair is a cementitious
shrinkage compensated mortar designed for all general purpose patch repairs.
It requires only on site addition of water to produce a high strength,
shrinkage compensated mortar that is non-corrosive,non-oxidising
and free of chlorides and nitrates.

USES
▪Patching of joints between precast and structuralcomponents
▪Repairs concrete structures and pre-cast components,e.g. damaged corners
▪Patch repairs to vertical,soffit and flooring concrete surfaces
▪Filling concrete cavities in electrical,piping and airconditioning works
▪Securing foundation and anchor bolts,pipe clips,sanitary wares,etc.
▪Repair concrete conduits,drains,etc.
▪Surface irregularities repairs including exposed aggregates,
joints between new and old concrete,protruding steel,tie-rod holes in formwork concrete,etc

CHARACTERISTICS / ADVANTAGES
▪ Non-bleeding and non-segregation
▪ Shrinkage-compensating
▪ High early compressive and flexural strength
▪ Non-corrosive
▪ Chlorides and iron free
▪ Pre-mixed to eliminate site variations and errors

APPLICATION INSTRUCTIONS
SUBSTRATE QUALITY / PRE-TREATMENT
Substrate should be cleaned and roughened. All loose
materials and free water must be removed. Damp the
substrate with water before application.

MIXING
For optimum result, mechanical mixer should be
used. The recommended amount of water (3.6–4.5 L)
should be measured and poured into the mixer. Slowly
add Sika MonoTop®-222 Patch Repair and mix continuously for 4 to 5 minutes.

APPLICATION
Use a steel trowel to apply the mixed material
onto the repair area. If the area that needs to be rectified is congested and cannot be reached with a trowel,
use hands (wearing gloves) to push the pasty grout
against the substrate and then trowel to a smooth finish. For application of joints between adjacent
precast components, ensure that the material covers
the joint spaces thoroughly.
For horizontal joints, the subsequent precast component should be laid onto the grout within the pot life
after mixing, depending on ambient temperature and
conditions.

COLOUR : GREY POWDER

PACKING : 25KG